28%乙.嗪可湿性粉剂防除大豆田杂草

乙。嗪可湿性粉剂虽一次性大豆田除草剂。试验结果表明，亩用有效剂量６０克，除草效果达９０％以上，对大豆安全，扩大了杀草谱，可防除整个大豆生长期杂草。     

固体硫在超临界/近临界酸性流体中的溶解度(Ⅰ)实验研究

建立了1套静态法测定难挥发物质(固体或液体)在超临界/近临界流体中溶解度的实验装置,并测定了固体硫在近临界硫化氢、超临界CO_2、CH_4及富硫化氢酸性气体混合物中的溶解度数据,取得了较好的结果.     

液压钟帽不停风卸灰装置

在考察了国内现行的不停风星形卸灰装置后，针对其利弊，开发了以钟帽为密封阀，液压为动力的不停风卸灰装置，从而提高了国产竖式混料石灰窑的产量，应用效果良好。     

熔块中的气泡缺陷及其解决办法

分析了熔块生产中气泡缺陷产生的各种原因．提出了实际生产中的注意事项和具体的解决办法。     

Efficient data selection for speech recognition based on prior confidence estimation using speech and monophone models

This paper proposes an efficient speech data selection technique that can identify those data that will be well recognized. Conventional confidence measure techniques can also identify well-recognized speech data. However, those techniques require a lot of computation time for speech recognition processing to estimate confidence scores. Speech data with low confidence should not go through the time-consuming recognition process since they will yield erroneous spoken documents that will eventually be rejected. The proposed technique can select the speech data that will be acceptable for speech recognition applications. It rapidly selects speech data with high prior confidence based on acoustic likelihood values and using only speech and monophone models. Experiments show that the proposed confidence estimation technique is over 50 times faster than the conventional posterior confidence measure while providing equivalent data selection performance for speech recognition and spoken document retrieval.     

含CO2气体混合物在60℃时的混合性质

测定了６０℃和２－６００ｂａｒ时由ＣＯ２和Ｈｅ、Ａｒ、ＳＦ６以及ＣＨＦ３组成的等分子二元混合物的压缩因子，根据纯物质和混合物的压缩因子计算了压力混合效应和过剩体积。对于真实气体混合性质的描述，本文采用五参数的ＢＡＣＫ方程，方程计算值与实验值符合较好。     

二元混合氯化盐的配制及热物性研究

在太阳能热发电技术中,硝酸盐类相变材料是使用最多的一种相变材料,但其最高使用温度仅为600 ℃,因此找到一种热容量大、工作温度范围宽、热损失低、价格便宜的相变储热材料是目前的研究重点。选取氯化锂和氯化钠两种高温熔盐相变材料按照不同的质量比混合制备了9种二元熔盐混合物,利用差式扫描量热仪（DSC）对其在600 ℃范围内的相变温度和相变潜热进行了研究。实验结果显示：由于氯化钠的熔点较高,当氯化锂和氯化钠的二元混合物中氯化钠的含量较多时,即氯化锂的含量较少时,少量的氯化锂不能将混合物的熔点降低至600 ℃以下,混合材料无法熔化;当氯化钠和氯化锂发生熔融时,无论何种比例其相变温度均保持在540 ℃左右,浮动±15 ℃;以质量配比为90%氯化锂-10%氯化钠的二元混合物的熔融温度与结晶温度相差较大,所以该二元混合熔盐可以应用于太阳能发电的传热和蓄热技术中。     

常见塑料溶解性能研究及其混合物的选择性分离

以常见塑料为原料,以有机物为溶剂,研究了塑料在有机溶剂中的溶解性能,提出了选择性分离混合塑料的方案。结果表明,实验所选用的塑料在有机溶剂中的溶解性能和溶解条件不同;可利用塑料与有机溶剂的相容性差别分离混合塑料。     

NPHMC: An R-package for estimating sample size of proportional hazards mixture cure model

Due to advances in medical research, more and more diseases can be cured nowadays, which largely increases the need for an easy-to-use software in calculating sample size of clinical trials with cure fractions. Current available sample size software, such as PROC POWER in SAS, Survival Analysis module in PASS, powerSurvEpi package in R are all based on the standard proportional hazards (PH) model which is not appropriate to design a clinical trial with cure fractions. Instead of the standard PH model, the PH mixture cure model is an important tool in handling the survival data with possible cure fractions. However, there are no tools available that can help design a trial with cure fractions. Therefore, we develop an R package NPHMC to determine the sample size needed for such study design.     

Dehydration of tetrahydrofuran by pervaporation using crosslinked PVA/PEI blend membranes

Dense blend membranes were prepared by blending hydrophilic polymers poly(vinyl alcohol) (PVA) and poly(ethyleneimine) (PEI), which were then crosslinked by glutaraldehyde (GA) in a mixture of solvents under the catalysis of hydrochloric acid (HCl) for the dehydration of tetrahydrofuran (THF) by pervaporation. The effect of experimental parameters such as feed water concentration, permeate pressure, and membrane thicknesses on permeate parameters, i.e., flux and selectivity were determined with feed water concentration less than 40 wt %. The membranes were found to have good potential for breaking the azeotrope of 94 wt % THF with a flux of 1.072 and 0.376 kg/m² h for plane PVA/PEI and crosslinked PVA/PEI blend membrane, which exhibited high selectivity of 156 and 579 respectively. Selectivity was found to improve with decreasing feed water concentration and increasing membrane thickness, whereas flux decreased correspondingly. High permeate pressure causes a reduction in both flux and selectivity. These effects were clearly elucidated with the aid of the known relationship among plasticization effect, degree of swelling, permeate pressure, and feed water concentration. These blend membranes were also subjected to sorption studies to evaluate the extent of interaction and degree of swelling in pure as well as binary feed mixtures. Further ion exchange capacity studies were carried out for all the crosslinked and uncrosslinked membranes to determine the total number of interacting groups present in the membranes. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 1152–1161, 2006